Interactive Monitoring Map 
Back

Firebag

AMS 17 - Wapasu

(Longitude: -110.90004 Latitude: 57.23732)

Firebag AMS was established in 2014 to monitor industrial emissions in the region of the Firebag SAGD operation. It is located near Suncor Firebag Village, near the Firebag SAGD operation.

The Firebag station contains analyzers that continuously measure SO2, THC, NO, NO2, NOx, H2S, wind speed, wind direction, temperature and humidity.

Current Data

Time of Data:
2017-07-22 05:00:00 (Mountain Standard Time)
ParameterHourly Average
SO2
-0.25 ppb
H2S
0.45 ppb
THC
2.15 ppm
NO
-0.03 ppb
NO2
0.69 ppb
NOx
0.66 ppb
Wind
Speed
@ 10m
13.96 km/h
Wind
Direction
@ 10m
194.80 deg.
Relative
Humidity
90.30 %
Temp
@ 2m
13.96 deg. C

All air quality monitoring data displayed on this site by the Wood Buffalo Environmental Association is directly from monitoring equipment output signals. Displayed data is generally indicative of ambient conditions, however, it has not been reviewed, validated, nor processed for baseline drift and other fluctuations by qualified technicians. Final processed and validated data values may vary from values displayed on this site. A displayed value of 'n/d' indicates air monitoring data is not available at the corresponding time due to scheduled maintenance and/or instrument calibration. Charted data is locked to the range of the analyzer by default, and can be unlocked by the appropriate control. To access quality-checked and validated historical data, please visit the Alberta Government's airdata warehouse: http://airdata.alberta.ca/

Historical Monitoring Data
 

PLEASE NOTE: When ambient concentrations of any pollutant WBEA measures exceeds the Alberta Ambient Air Quality Objective, WBEA has an immediate Reporting Protocol that is put into action. WBEA analyzers continuously monitor ambient air, and in the event of an exceedence the following steps are taken:

1 - The data collection system automatically sends out alarm notifications to WBEA personnel and an independent third party alarm monitoring company. 

2 - The alarm company acknowledges the incoming alarm and reports the data and supporting information such as wind conditions, locations, time, etc, to Alberta Environment & Parks (AEP) in real time, or as soon as becoming aware of it.

3 - AEP uses the data and information from WBEA to follow up as appropriate.