Interactive Monitoring Map 
Back

Community AMS - Athabasca Valley

AMS 7 - Athabasca Valley

(Longitude: -111.39020 Latitude: 56.73268)

The Athabasca Valley AMS is a community station located on MacDonald Drive near MacDonald Island Park. This station was built and operated by Alberta Environment until WBEA took over maintenance and operation in the fall of 1997.

The Athabasca Valley AMS contains analyzers that continuously measure SO2, TRS, THC, O3, NO, NO2, NOX, PM2.5, CO, wind speed and direction, and temperature.Non-continuous measurement devices include a PM10, VOCs, and semi-volatile organic compounds.

Current Data

Time of Data:
2017-05-26 11:00:00 (Mountain Standard Time)
ParameterHourly AverageAlberta Ambient Air Quality Objective
CO 0.21 ppm13 ppm
SO2 Cal172 ppb
TRS 0.43 ppb10 ppb
NO 1.59 ppb
NO2 3.27 ppb159 ppb
NOX 4.53 ppb
THC 1.99 ppm
O3 26.92 ppb82 ppb
PM2.5 7.86 ug/m3
NMHC
0.00 ppm
CH4
1.99 ppm
Temp @ 2m 13.63 deg. C
Wind Speed @ 10m 12.47 km/h
Wind Dir. @ 10m 354.60 deg.
Barometric Pressure 28.76 inHg

All air quality monitoring data displayed on this site by the Wood Buffalo Environmental Association is directly from monitoring equipment output signals. Displayed data is generally indicative of ambient conditions, however, it has not been reviewed, validated, nor processed for baseline drift and other fluctuations by qualified technicians. Final processed and validated data values may vary from values displayed on this site. A displayed value of 'n/d' indicates air monitoring data is not available at the corresponding time due to scheduled maintenance and/or instrument calibration. Charted data is locked to the range of the analyzer by default, and can be unlocked by the appropriate control. To access quality-checked and validated historical data, please visit the Casa Data Warehouse: www.casadata.org
 

Historical Monitoring Data

PLEASE NOTE: When ambient concentrations of any pollutant WBEA measures exceeds the Alberta Ambient Air Quality Objective, WBEA has an immediate Reporting Protocol that is put into action. WBEA analyzers continuously monitor ambient air, and in the event of an exceedence the following steps are taken:

1 - The data collection system automatically sends out alarm notifications to WBEA personnel and an independent third party alarm monitoring company. 

2 - The alarm company acknowledges the incoming alarm and reports the data and supporting information such as wind conditions, locations, time, etc, to Alberta Environment & Sustainable Resource Development (AESRD) in real time, or as soon as becoming aware of it.

3 - As the provincial regulator, AESRD uses the data and information from WBEA to follow up as appropriate.