Interactive Monitoring Map 
Back

Conklin

Community AMS - Conklin AMS21

 

The Conklin Air Monitoring Station is located near the Conklin Resource Development Advisory Committee office, on Father Mercredi’s Trail in the community of Conklin (Latitude, Longitude: 55.632331, -111.078872). The Conklin monitoring station commenced operation in April 2016.

The Conklin station contains analyzers that continuously measure Sulphur Dioxide (SO2), Total Reduced Sulphur (TRS), Nitric Oxide (NO), Oxides of Nitrogen (NOx),Nitrogen Dioxide (NO2), Total Hydrocarbons (THC), Non Methane Hydrocarbons (NMHC), Methane (CH4), fine particulate matter (PM2.5), wind speed and direction, temperature, and relative humidity.

For more information regarding the Conklin Air Monitoring Station, please see the station site documentation.

Current Data

Time of Data:
2017-11-22 14:00:00 (Mountain Standard Time)
ParameterHourly Average
SO2
0.12 ppb
TRS
0.41 ppb
NO2
3.10 ppb
NOx
3.83 ppb
NO
0.73 ppb
O3
28.76 ppb
NMHC
0.00 ppm
CH4
1.96 ppm
THC
1.96 ppm
PM2.5 4.40 ug/m3
Wind
Speed
@ 10m
4.97 km/h
Wind
Direction
@ 10m
233.10 deg.
Relative
Humidity
67.02 %
Temp
-8.24 deg. C

All air quality monitoring data displayed on this site by the Wood Buffalo Environmental Association is directly from monitoring equipment output signals. Displayed data is generally indicative of ambient conditions, however, it has not been reviewed, validated, nor processed for baseline drift and other fluctuations by qualified technicians. Final processed and validated data values may vary from values displayed on this site. A displayed value of 'n/d' indicates air monitoring data is not available at the corresponding time due to scheduled maintenance and/or instrument calibration. Charted data is locked to the range of the analyzer by default, and can be unlocked by the appropriate control. To access quality-checked and validated historical data, please visit the Alberta Government's airdata warehouse: http://airdata.alberta.ca/

Historical Monitoring Data
 

PLEASE NOTE: When ambient concentrations of any pollutant WBEA measures exceeds the Alberta Ambient Air Quality Objective, WBEA has an immediate Reporting Protocol that is put into action. WBEA analyzers continuously monitor ambient air, and in the event of an exceedence the following steps are taken:

1 - The data collection system automatically sends out alarm notifications to WBEA personnel and an independent third party alarm monitoring company. 

2 - The alarm company acknowledges the incoming alarm and reports the data and supporting information such as wind conditions, locations, time, etc, to Alberta Environment & Parks (AEP) in real time, or as soon as becoming aware of it.

3 - AEP uses the data and information from WBEA to follow up as appropriate.